Table of Contents
Advertisement
Reinstalling Components After Installing the Chassis
Reinstalling the Blower Module
Step 1
Caution
Figure 3-22
Installing the Blower Module
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
3-30
Use the following procedure to reinstall the blower module in the chassis.
Install the blower module into the chassis
Lift the blower module (with two hands) and slide it halfway into the module
a.
bay.
Slowly push the blower module into the chassis until it mates with the
b.
backplane connector at the back of the module bay.
To prevent damage to the connectors, do not use excessive force when inserting
the blower module into the chassis.
Tighten the captive screws on the blower module to secure it to the chassis.
c.
Chapter 3
Installing the Cisco XR 12410 Router
(Figure
3-22):
OL-17441-01
Advertisement
Table of Contents
Troubleshooting
