Table of Contents
Advertisement
Chapter 5
Maintaining the Router
Step 2
Figure 5-25
Removing a Card from the Switch Fabric and Alarm Card Cage
Clock scheduler card
Air filter door
Step 3
Step 4
Removing and Installing a Chassis
OL-17441-01
Remove the card (a CSC in this example):
Pivot the ejector levers to unseat the card from the backplane connector.
a.
b.
Grasp the card by its metal card carrier and slide the card out of the
slot
(Figure
5-25).
Place the card directly into an antistatic bag or other ESD-preventive
–
container.
To install the card, reverse the procedure in Step 2.
Close the air filter door and tighten the captive screws.
This section provides the procedures to remove and replace a chassis. You may
need to perform this procedure to replace a defective chassis or move it to another
location. These instructions include the steps directing you to removal and
replacement instructions for individual components such as power supplies and
line cards.
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
Removing and Installing a Chassis
5-41
Advertisement
Table of Contents
Troubleshooting
