Cisco IE 3000 Getting Started Manual page 6
Cisco systems switch user manual
Hide thumbs
Also See for IE 3000:
- Software configuration manual (760 pages) ,
- Hardware installation manual (186 pages) ,
- Command reference manual (802 pages)
Table of Contents
Advertisement
Step 1
Make sure that nothing is connected to the
switch.
During Express Setup, the switch acts as a
DHCP server. If your PC has a static IP
address, change your PC settings before you
begin to temporarily use DHCP.
Step 2
Connect power to the switch.
See the wiring instructions in the
the DC Power Source" section on page
Step 3
When the switch powers on, it begins the power-on self-test (POST). During POST, the
System LED blinks while a series of tests verify that the switch functions properly. Wait for
the switch to complete POST, which takes approximately 1 minute.
Step 4
Make sure that POST has completed by verifying that the System LED is solid green. If the
switch has not been configured, the Setup LED blinks green. If the Setup LED stops blinking,
you can still continue with the next step.
If the switch fails POST, the System LED turns red. See the
on page 25
if your switch fails POST.
Step 5
Press the Express Setup button. This button is
recessed behind the front panel, so you can
use a simple tool, such as a paper clip.
When you press the Express Setup button, a
switch port LED begins blinking green.
Cisco IE 3000 Switch Getting Started Guide
6
To run Express Setup:
"Grounding the Switch" section on page 17
Cisco IE 3000 Switch Getting Started Guide
18.
"In Case of Difficulty" section
E x p r e s s
S y s t e m
A l a r m
S e t u p
and the
"Wiring
S e t u p
P w r A
P w r B
2
OL-16234-01
Hide quick links:
Advertisement
Chapters
Table of Contents
