Removing Sfp Modules From Sfp Module Slots - Cisco IE 3000 Series Hardware Installation Manual
Cisco systems switch installation guide
Hide thumbs
Also See for IE 3000 Series:
- Software configuration manual (760 pages) ,
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages)
Table of Contents
Advertisement
Connecting Destination Ports
Step 6
Insert the LC cable connector into the SFP module.
Removing SFP Modules from SFP Module Slots
To remove an SFP module from a module receptacle, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a grounded bare metal surface.
Step 1
Disconnect the LC from the SFP module.
Step 2
Step 3
Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4
Unlock and remove the SFP module. See
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp
latch is obstructed and you cannot use your index finger to open it, use a small, flat-blade screwdriver
or other long, narrow instrument to open the bale-clasp latch.
Figure 2-34
1
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module
Step 5
slot.
Place the removed SFP module in an antistatic bag or other protective environment.
Step 6
Cisco IE 3000 Switch Hardware Installation Guide
2-40
Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
1
Bale clasp
Figure
2-34.
Chapter 2
Switch Installation
OL-13017-01
Hide quick links:
Advertisement
Table of Contents
