Table of Contents
Advertisement
LCD PANEL ASSEMBLY REMOVAL
LCD PANEL ASSEMBLY HANDLING INSTRUCTIONS
Use the following precautionary guidelines when handling the LCD Panel Assembly to avoid material degradation or
screen coating degradation.
A After removing the boards and connectors, note where the frame is on the LCD Panel. (Figure 1)
B Lift the LCD Panel by holding the top and bottom of the panel no less than 200 mm from the edge with your
palms on the back of the panel. (Figure 2)
C When setting the LCD Panel down, gently place the panel onto a soft cloth on a flat surface. (Figure 3)
200mm
XBR-65HX955
FIGURE 1
200mm
FIGURE 2
FIGURE 3
SECTION 4 - DISASSEMBLY/PART NUMBER INFORMATION
NOTE:
The
components
identified
shading and
mark are critical for safety.
!
Replace only with part number specified.
CAUTIONS:
DO NOT lift the panel by holding the short side of the panel or by only holding the glass. (Figures 4 & 5)
DO NOT hold the panel with your palms on the front glass or by holding the panel at the corners of the panel. (Figure 6)
DO NOT place the panel down on its edge. (Figure 6)
NOTE: The components identified by a red outline and a
by
contain confidential information. Specific instructions must be
adhered to whenever these components are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
CAUTION: The LCD Panel
bends when holding the short
side of the panel.
FIGURE 4
FIGURE 5
FIGURE 6
mark
22
Advertisement
Table of Contents
