Appendix C
Configuring the Switch with the CLI-Based Setup Program
Uninstalling the Cisco Microsoft Windows USB Driver Using the Setup.exe Program
Disconnect the switch console terminal before uninstalling the driver.
Note
Run setup.exe for Windows 32-bit or setup(x64).exe for Windows 64-bit. Click Next.
Step 1
Step 2
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 3
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 4
When the Remove the Program window appears, click Remove.
For Windows Vista or 7, if a User Account Control warning appears, click Allow - I trust this program
Note
to proceed.
Step 5
When the InstallShield Wizard Completed window appears, click Finish.
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch
is powered on. You must assign an IP address and other configuration information necessary for the
switch to communicate with the local routers and the Internet. This information is also needed to use
Device Manager or Cisco Network Assistant to configure and manage the switch.
IP Settings
You need this information from your network administrator:
•
•
•
•
•
•
Configuring the Setup Program
If your switches are stacked and there are multiple console connections to individual switches in the
stack, the initial setup dialog appears at the console where you first press Enter.
Completing the setup program and an initial configuration for the switch:
Enter Yes at the following two prompts:
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: yes
OL-29734-01
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password
Enable password
Telnet password
Entering the Initial Configuration Information
Catalyst 3650 Switch Hardware Installation Guide
C-5