Figure 5-5: Ppoe: Internet Connection Type; Figure 5-6: Ppoe: Network Address Server Settings (Dhcp) - Linksys WRT330N User Manual

Wireless-n gigabit gaming router

Hide thumbs Also See for WRT330N:

Table of Contents

Wireless-N Gigabit Gaming Router

The SETUP Tab - BASIC SETUP - PPPoE

Internet Connection Type

Some DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to establish Internet connections for

end-users. If you use a DSL line, check with your ISP to see if they use PPPoE. If they do, you will have to enable

it.

User Name and Password. Enter the User Name and Password provided by your ISP.

Service Name. If provided by your ISP, enter the Service Name.

Connect on Demand and Max Idle Time. You can configure the Router to cut the Internet connection after it has

been inactive for a specific period of time (Max Idle Time). If your Internet connection has been terminated due to

inactivity, Connect on Demand enables the Router to automatically re-establish your connection as soon as you

attempt to access the Internet again. To use Connect on Demand, click the radio button. If you want your Internet

connection to remain on at all times, enter 0 in the Max Idle Time field. Otherwise, enter the number of minutes

you want to have elapsed before your Internet access disconnects.

Keep Alive and Redial Period. This option keeps your Internet access connected indefinitely, even when it sits

idle. If you select this option, the Router will periodically check your Internet connection. If the connection is

down, then the Router will automatically re-establish the connection. To use this option, click the radio button

next to Keep Alive. The default Redial Period is 30 seconds.

Network Address Server Settings (DHCP)

DHCP Server. The Router can be used as a Dynamic Host Configuration Protocol (DHCP) server for your network.

A DHCP server automatically assigns an IP address to each computer on your network. Unless you already have

one, it is highly recommended that you leave the Router enabled as a DHCP server.DHCP is enabled by factory

default. If you already have a DHCP server on your network, set the Router's DHCP option to Disable.

Starting IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. Because the

default IP address for the Router is 192.168.1.1, the Start IP Address must be 192.168.1. 2 or greater, but smaller

than 192.168.1.254. The default Start IP Address is 192.168.1.100.

Maximum Number of DHCP Users (Optional). Enter the maximum number of PCs that you want the DHCP server

to assign IP addresses to. This number cannot be greater than 253. The default is 50.

Client Lease Time. The Client Lease Time is the amount of time a network user will be allowed connection to the

Figure 5-4: SEUP: BASIC SETUP: PPoE Settings

Router with their current dynamic IP address. Enter the amount of time, in minutes, that the user will be "leased"

Chapter 5: Configuring the Wireless-N Gigabit Gaming Router

The SETUP Tab - BASIC SETUP - PPPoE

Table of Contents

Wireless-n gigabit gaming router