Table of Contents
Advertisement
Replacing Modules
Warning
Before you begin
• Wear electrostatic discharge (ESD) wrist strap or other ESD protective device while handling the module.
• Prepare an antistatic surface or packing materials for the module that you remove from the chassis.
Step 1
Open the packaging for the new Switch Card and inspect the module for damage.
For a damaged module, contact the Technical Assistance Center (TAC).
Step 2
To remove the module follow these steps:
a) Loosen the thumb screws that attach the module to the chassis (4), as shown in the following figure.
b) Push the lever button (2) to release the lever, as shown in the following figure.
c) Disengage the lever (2) by pulling it out and away from the chassis, as shown in the following figure.
d) Carefully remove the module.
Statement 1034 Backplane Voltage
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
servicing.
Cisco Nexus 9408 NX-OS Mode Switch Hardware Installation Guide
Replacing a Switch Card
37
Advertisement
Table of Contents
