Mounting Hardware; Connecting To Wan - Cisco Meraki Z3C Installation Manual
Hide thumbs
Also See for Meraki Z3C:
- Installation manual (6 pages) ,
- Hardware installation manual (15 pages)
Table of Contents
Advertisement
Mounting hardware
The supplied wall screws and anchors allow you to mount the gateway on a drywall surface, either vertically or
horizontally.
• For mounting on drywall, use a ¼-in drill bit, then insert the plastic and screw assemblies.
• For mounting on wood or a similar surface, use only the screws.
• Allow the heads of the screws to stick out far enough to be inserted securely into the back of the gateway.
• This equipment is only suitable for mounting at heights ≤ 2 m
• Warning: This equipment may not work when mains power fails.
Connecting to WAN
All Meraki Z3C devices must have an IP address. This section describes how to configure your local area network
before you deploy it. A local management web service, running on the gateway, is accessed through a browser running
on a client PC. This web service is used for configuring and monitoring basic ISP/WAN connectivity.
5
Advertisement
Table of Contents
