Rear View - IBM System x3850 Installation Manual

Hide thumbs Also See for System x3850:

Table of Contents

v System-error LED: When this LED is lit, it indicates that a system error has

v Locator LED: When this LED is lit, it has been lit remotely by the system

v Hard disk drive activity LED: When this LED is flashing, it indicates that a SAS

v Power-on LED: When this LED is lit and not flashing, it indicates that the server

DVD-eject button: Press this button to release a CD or DVD from the DVD drive.

DVD drive activity LED: When this LED is lit, it indicates that the DVD is in use.

Electrostatic-discharge connector: Connect an electrostatic-discharge wrist strap

to this connector.

Rear view

The following illustration shows the connectors and LEDs on the rear of the server.

Power-supply connector: Connect the power cord to this connector.

Video connector: Connect a monitor to this connector.

USB 1 connector: Connect a USB device to this connector.

IBM System x3850 Type 8864: Installation Guide

occurred. An LED on the light path diagnostics panel is also lit to help isolate the

error.

administrator to aid in visually locating the server.

hard disk drive is in use.

is turned on. When this LED is flashing, it indicates that the server is turned off

and still connected to an ac power source. When this LED is off, it indicates that

ac power is not present, or the power supply or the LED itself has failed.

Note: If this LED is off, it does not mean that there is no electrical power in the

server. The LED might be burned out. To remove all electrical power from the

server, you must disconnect the power cords from the electrical outlets.

Table of Contents

8864