Table of Contents
Advertisement
Applicable lens unit: NP31ZL
1. Focus on the projected image around the optical axis. (Powered focus)
Press the FOCUS +/− button until you can obtain the best focus.
(The FOCUS adjustment bar will be displayed on.)
The drawing below shows an example when the projected image is shifted upward. In this case the optical axis
is at the bottom edge of the projected image.
Adjusting with buttons on the cabinet
Press the FOCUS +/− BUTTON on the control panel
• ◀ or ▶ buttons on the cabinet or the remote control are also available to adjust FOCUS while the FOCUS
adjustment bar is displayed on.
* When the lens is at the center position, the optical axis is at the center of the image. In this case, adjust the
focus at the center of the projected image.
2. Projecting an Image (Basic Operation)
Adjusting with the remote control
Press the VOL/FOCUS button holding the CTL button
Optical axis
27
Advertisement
Table of Contents
