Table of Contents
Advertisement
Installing a Cable Management Bracket
Step 4
Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to ensure a
proper mechanical connection.
Step 5
Insert the two screws through the holes in the grounding lug. Ensure that the grounding lug does not interfere
with other router hardware components.
Step 6
Use the Phillips screwdriver to carefully tighten the screws to 60 in-lbs 6.7 (N-m) of torque until the grounding
lug is held firmly to the chassis. Do not overtighten the screws.
Step 7
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an
adequate chassis ground.
What to do next
Install cable management brackets.
Installing a Cable Management Bracket
To install a cable-management bracket, follow these steps:
Note
Before you begin
The chassis must be installed and secured to the rack.
Required tools and equipment:
• Phillips screwdriver with a torque capability (customer supplied)
• Cable management brackets (8608-CBLMGMT).
Note
Procedure
Step 1
Insert the alignment pins on top of the chassis.
Step 2
Position the top hood of the cable management assembly with its brackets pointing down.
Step 3
After you finish the alignment of the top hood with the chassis, secure it with counter sink screws and M4 x
18-mm screws.
Hardware Installation Guide for Cisco 8600 Series Routers
38
• This procedure is applicable for Cisco 8608 chassis.
• The cable management brackets for Cisco 8608 chassis supports only optics cables.
• The cable management brackets are shipped with the chassis.
• The cable management bracket comes with a top hood.
Unpack and Install the Chassis
Advertisement
Table of Contents
