Table of Contents
Advertisement
Figure 41. Installing PERC card into internal PERC riser
Next steps
1.
Installing the internal PERC riser
2.
Installing the air shroud
3. Follow the procedure listed in
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Removing the air shroud
4.
Removing the internal PERC riser
Steps
1. Disconnect the intrusion switch cable connected to the system board.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board.
2. Slide the intrusion switch out of the intrusion switch slot.
52
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
