Removing The Power-Supply Sleeve - IBM System x3800 Manual
Hide thumbs
Also See for System x3800:
- Problem determination and service manual (198 pages) ,
- User manual (104 pages) ,
- Installation manual (88 pages)
Table of Contents
Advertisement
3. Install the adapters.
4. Install the top cover and front cover (tower model only) (see "Replacing the top
5. Connect the cables and power cords (see "Connecting the cables" on page 118
6. Turn on all attached devices and the server.
Removing the power-supply sleeve
To remove the power-supply sleeve, complete the following steps.
Power supply
sleeve
10. Grasp the handle in the middle of the power-supply sleeve and pull the sleeve
154
IBM System x3800 Type 8865: Problem Determination and Service Guide
cover, bezel, and front cover" on page 121).
for cabling instructions).
Power supply
Retainer bar
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 115.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables necessary to replace the device.
3. Remove the front cover (tower model only), top cover, and bezel (see
"Removing the top cover, bezel, and front cover" on page 119).
4. Remove the power supplies (see "Removing the hot-swap power supply and
power supply filler" on page 125).
5. Remove all fans (see "Removing the hot-swap fan" on page 123).
6. Remove the memory cards (see "Removing and replacing a memory card" on
page 126).
7. Lift the microprocessor-tray release latch, open the microprocessor-tray levers,
and pull the microprocessor tray out of the server slightly (see "Removing and
installing a microprocessor" on page 147).
8. The power backplane retention lever on the rear of the server will fall, allowing
the power backplane to lower into the bottom half of the server chassis.
9. Remove the power backplane from the rear of the sleeve.
out of the server.
Handle
Advertisement
Table of Contents
