Table of Contents
Advertisement
OBJ_BUCH-1603-003.book Page 7 Wednesday, April 19, 2017 2:16 PM
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The machine is intended for cutting, roughing and brushing of
metal and stone materials without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 On/Off switch
3 Auxiliary handle (insulated gripping surface)*
4 Grinder spindle
5 Protection guard for grinding
6 Locking screw for protection guard
7 Mounting flange
8 Grinding wheel*
9 Clamping nut
10 Two-pin spanner for clamping nut*
11 Protection guard for cutting*
12 Cutting disc*
13 Hand guard*
14 Rubber sanding plate*
15 Sanding sheet*
16 Round nut*
17 Cup brush*
18 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Bosch Power Tools
Technical Data
Angle Grinder
Article number
Rated power input
Output power
Rated speed
min
Grinding disc diameter, max.
Thread of grinder spindle
Thread length (max.) of grinder
spindle
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For differ-
ent voltages and models for specific countries, these values can vary.
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull the mains
plug.
Note: After breakage of the grinding disc during operation or
damage to the holding fixtures on the protection guard/power
tool, the machine must promptly be sent to an after-sales ser-
vice agent for maintenance for addresses, see section "After-
sales Service and Application Service".
Protection Guard for Grinding
Place the protection guard 5 on the
spindle collar. Adjust the position
of the protection guard 5 to the re-
quirements of the operation and
lock the protection guard 5 with
the locking screw 6.
Adjust the protection guard 5 in such a manner that
sparking is prevented in the direction of the operator.
Note: The encoding keys on the protection guard 5 ensure
that only a protection guard that fits the machine type can be
mounted.
Protection Guard for Cutting
For cutting with bonded abrasives, always use the pro-
tection guard for cutting 11.
Provide for sufficient dust extraction when cutting
stone.
The protection guard for cutting 11 is mounted in the same
manner as the protection guard for grinding 5.
1 609 92A 0M3 | (19.4.17)
English | 7
PWS 620-100
3 603 D14 0..
W
620
W
300
-1
11500
mm
100
M 10
mm
10
kg
1.6
/II
Advertisement
Table of Contents
