Table of Contents
Advertisement
Module parameter
The setting values of the module parameters are shown below.
Setting item
Logging function enable/disable
Logging data file storage type
FTP server IP address
Login name
Password
FPGA control automatic start setting
FPGA parameter
The setting values of the FPGA parameters to be set are shown below.
Setting item
Data sampling timing (E0)
A/D conversion enable/disable setting (E0)
Select A/D conversion timing CH0 (E0)
ADC range setting CH0 (E0)
Logging operation mode setting
Buffer operation setting
Select logging start control
Select sampling pulses
Logging data size setting
Logging data time division setting
*1 When logging A/D conversion values in time division mode, set the user circuit output. If anything other than user circuit output is set,
logging will not be performed properly.
User circuit part parameter
The setting values of the user circuit part parameters to be set are shown below.
Address
1000_B122H (writing data 145)
1000_B126H (writing data 147)
1000_B12AH (writing data 149)
Setting value
Enable
Binary file
IP address of the FTP server to be used
Login name of the FTP server to be used
Password of the FTP server to be used
Enable
Setting value
10.00s
Conversion-enable
Data sampling timing
Align with the analog signal output from the sensor.
Storage operation mode
Linear buffer operation
User circuit output
User circuit output
256 records
Time division mode
Setting item
User circuit part parameter size
Logging control part logging enable signal selection (usr_wreg_091)
Logging control part sampling pulse signal selection (usr_wreg_093)
Logging control part automatic transfer mode setting (usr_wreg_095)
*1
*1
13 SAMPLE CIRCUIT IN STANDALONE MODE
13.5 When Using the Logging Function
13
Setting value
384
7H
15H
1H
391
Advertisement
Table of Contents
Troubleshooting
