Table of Contents
Advertisement
Setting method
The procedure using the FPGA Module Configuration Tool is shown below.
Operating procedure
1.
Create the project with the following settings.
Set NZ2GN2S-D41P01 as the connected main module and NZ2EX2S-D41A01 as the connection extension module.
[Project] [New]
2.
Click the [OK] button.
3.
Enter the IP address of the FPGA module to be connected in the "Connection destination setting" window.
[Menu] [Connection destination setting]
4.
Click the [Communication Test] button.
5.
Click the [OK] button.
6.
Click the [Apply] button.
7.
From the "Module Parameter" window, set the values of the module parameters.
[Menu] [Module Parameter]
14 SAMPLE CIRCUIT IN CC-LINK IE TSN COMMUNICATION MODE
418
14.7 When Using the Logging Function
Advertisement
Table of Contents
Troubleshooting
