Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Siemens SN66P092EU
Summary of Contents for Siemens SN66P092EU
- Page 1 SN… SX…...
-
Page 3: Table Of Contents
Table of contents Intended use ....4 Utensils ....13 Not suitable. -
Page 4: Intended Use
Intended use Remaining running time Intended use display ..... . . 24 Timer programming ... . . 24 I n t e n d e d u s e End of programme . -
Page 5: Before You Switch On The Appliance
Safety instructions Children must not play with, on, Delivery or around the appliance. 1. Check the packaging and Children must not clean the dishwasher immediately for appliance or carry out general damage caused in transit. Do maintenance unless they are at not switch on a damaged least 8 years old and are being appliance, but contact your... - Page 6 Safety instructions The electrical connection If you cannot obtain any conditions must correspond information from with the specifications the manufacturer, you must on the dishwasher rating not install the dishwasher plate 9B. above or below these appliances. If the power cord of this appliance is damaged, If you install a microwave it must be replaced with...
-
Page 7: In Daily Use
Safety instructions In daily use Warning Risk of injury! Read and observe the safety information and instructions To prevent injuries, e.g. for use on the packaging caused by stumbling, open for cleaning and rinsing agents. the dishwasher only briefly in order to load and unload the dishwasher. - Page 8 Safety instructions When opening and closing Warning the door on an eye-level Risks to children! appliance, ensure that If fitted, use the childproof children do not become lock. An exact description jammed or crushed between can be the appliance door and the found in the back of the enve cupboard door below.
-
Page 9: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c... -
Page 10: Appliance Interior
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * W a t e r s o f t e n i s y s t e m / S p e c i s a l t 1* Cutlery drawer To ensure good washing results, 12 Top basket... -
Page 11: Water Hardness Table
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately... -
Page 12: Detergents With Salt Component
Rinse aid Using detergents with salt Rinse aid component D e t e r g e n t s w i t h s a l t c o m p o n e n t R i n s e a i d As soon as the rinse-aid refill If combined detergents with a salt... -
Page 13: Setting Amount Of Rinse Aid
Utensils 3. Close cover until it clicks shut. Switching off rinse aid refill 4. To prevent excessive foam formation indicator during the next rinse cycle, remove any rinse aid which has run over with If the rinse-aid refill indicator H is a cloth. -
Page 14: Glass And Utensil Damage
Utensils Glass and utensil damage Unloading the dishwasher Causes: To prevent water from dripping off the upper basket onto the utensils in the Glass type and glass production lower basket, it is recommended process. to empty the appliance from the bottom Chemical composition of the detergent. -
Page 15: Pans
Utensils Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1B. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. a better dishwashing result. -
Page 16: Folding Spikes
Utensils Depending on the model, you can fold Small accessories holder * S m a l l a c c e s s o r i e s h o l d e r down the side shelves to provide more room for taller items of cutlery. -
Page 17: Detergent
Detergent 1. Pull out the top basket 12 out. Detergent 2. To lower the basket, press in the left and then the right lever on the D e t e r g e outside of the basket. In doing so, You can use tablets as well as powder hold the sides of the basket along or liquid detergents for dishwashers, but... -
Page 18: Adding Detergent
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 92 is still slightly less than the indicated amount closed, press the lock 9: to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 92 only (insert tablet flat,... - Page 19 Detergent Notes Even if the rinse-aid and/or salt refill indicator is lit, the rinse programme You will obtain optimum rinsing will run correctly with combined and drying results by using solo detergents. detergents and applying salt If using detergents in a water-soluble and rinse aid separately.
-
Page 20: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 21: Programme Selection
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling. -
Page 22: Operating The Appliance
Operating the appliance Zeolith drying Operating the appliance The appliance features a Zeolith container Zeolith is a mineral which can O p e r a t i i a n c e t h e a p p l store moisture and heat energy and release them again. -
Page 23: Switching On The Appliance
Operating the appliance Switching on the appliance Possible settings of the optical display: 1. Turn on the tap fully. The display is switched off. 2. Open the door. Programme, timer programming, 3. Switch on ON/OFF switch (. remaining time, end of programme and, if required, low water level are The Eco 50°... -
Page 24: Remaining Running Time Display
Operating the appliance Remaining running time End of programme display The programme has ended when the value : is indicated on the numerical When the programme is selected, the display h. remaining running time of the programme is indicated on the digital The end of the programme is also display h. -
Page 25: Automatic Switch Off
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;... -
Page 26: Interrupting The Programme
Operating the appliance Interrupting the programme Intensive drying 1. Open the door. The final rinse uses a higher temperature which improves the drying 2. Switch off ON/OFF switch (. result. The running time may increase The LEDs go out. The programme is slightly. -
Page 27: Cleaning And Maintenance
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C l e a n i a n d n a n c e m a i n t e and fascia with a damp cloth;... -
Page 28: Filters
Cleaning and maintenance Filters Spray arms The filters 1j keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1: and the pump. These foreign objects may occasionally block the filters. -
Page 29: Fault, What To Do
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2. -
Page 30: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min. - Page 31 Fault, what to do? Fault Cause Remedial action Error code : is lit. Waste water pump blocked or Clean pump and lock cover correctly. (See cover on the waste water pump is “Waste water pump”) not locked in position. Error code : is lit.
- Page 32 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 33 Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 34 Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 35 Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
- Page 36 Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
- Page 37 Fault, what to do? Fault Cause Remedial action Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray. out. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
-
Page 38: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 39: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 40: Drinking Water Connection
Installation and connection Drinking water connection Warm water connection * W a r m w a t e r c o n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max. -
Page 41: Electrical Connection
Installation and connection Setting hot water: Electrical connection 1. Open the door. 2. Switch on ON/OFF switch (. Connect the appliance to an alternating current only, ranging from 3. Hold down programme button # 220 V to 240 V and 50 Hz or 60 Hz and press START button ` via a correctly installed socket with until : ... -
Page 42: Removing The Appliance
Installation and connection Removing the appliance Transportation Also observe Empty the dishwasher and secure loose the sequence of worksteps here. parts. 1. Disconnect the appliance from Drain the appliance according to the the power supply. following steps: 2. Turn off the water supply. 1. - Page 44 *9000908151* 9000908151 en (9508_*) 640MV...