Table of Contents
Advertisement
EN 75
... make sure the cassette is positioned properly
when inserting.
... do not load and unload the cassette
repeatedly without allowing the tape to run at
all. This slackens the tape and can result in
damage.
... do not open the front tape cover. This exposes
the tape to fingerprints and dust.
2. Store cassettes...
... away from heaters or other heat sources.
... out of direct sunlight.
... where they won't be subject to unnecessary
shock or vibration.
... where they won't be exposed
to strong
magnetic
fields (such as those generated
by
motors, transformers
or magnets).
... vertically,
in their original cases.
Memory Cards
To properly use and store your memory cards, be
sure to read the following
cautions:
1. During use...
... make sure the memory card bears the SD or
MukiMediaCard
mark.
... make sure the memory card is positioned
properly when inserting,
2. While the memory card is being accessed
(during recording, playback, deletion,
initialization, etc.)...
... never unload the memory card and never turn
off the camcorder,
3. Store memory cards...
... away from heaters or other heat sources.
... out of direct sunlight.
... where they won't be subject to unnecessary
shock or vibration.
... where they won't be exposed
to strong
magnetic
fields (such as those generated
by
motors, transformers or magnets).
LCD Monitor
1. To prevent damage to the LCD monitor,
DO NOT...
... push it strongly or apply any shocks.
_. place the camcorder
with the LCD monitor on
the bottom.
2. To prolong service life..,
... avoid rubbing it with coarse cloth.
3. Be aware of the following
phenomena
for LCD
monitor use.
These are not malfunctions:
• While using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
monitor may heat up.
• If you leave power on for a long time, the
surface around the LCD monitor becomes hot.
MainUnit
1. For safety, DO NOT...
... open the camcorder's chassis.
... disassemble or modify the unit.
... short-circuit
the terminals of the battery pack.
Keep it away from metallic objects when not
in use.
... allow inflammables, water or metallic objects
to enter the unit.
... remove the battery pack or disconnect the
power supply while the power is on.
... leave the battery pack attached when the
camcorder is not in use.
2. Avoid using the unit...
... in places subject to excessive humidity or
dust.
... in places subject to soot or steam such as near
a cooking stove.
... in places subject to excessive shock or
vibration.
... near a television
set.
... near appliances
generating
strong magnetic or
electric
fields (speakers,
broadcasting
antennas,
etc.b
... in places subject to extremely
high (over 40_C
or I04°F) or extremely
low (under O°C or
32"_F) temperatures.
3. DO NOT leave the unit...
... in pb_ces of over 50°C (122°F).
... in places where humidity
is extremely
low
(below 35%) or extremely
high (above 80%).
... in direct sunlight.
... in a dosed
car in summer.
... near a heater.
4. To protect
the unit, DO NOT.-
... allow it to become
wet.
... drop the unit or strike it against hard objects.
... subject it to shock or excessive
vibration
during transportation.
... keep the lens directed
at extremely
bright
objects for long periods.
... expose the lens and viewfinder's
lens to direct
sunhght,
... carry it by holding the LCD monitor or the
viewfinder.
... swing it excessively when using the hand strap
or the grip.
... swing the soft camera case excessively when
the camcorder is inside it.
5. Dirty heads can cause the following problems:
• No picture during playback.
• Blocks of noise appear during playback.
CONTINUED
ON NEXT PAGE
Advertisement
Table of Contents
