Advertisement
11-3-3 How to assemble the Wall Mount Bracket
1
Insert and tighten the Captive Screw in the direction of the arrow.
When done, mount the wall bracket on the wall.
2
Before drilling into the wall, check if the
length between the two locking holes at
the back of the product is correct.
If the length is too short or long, loosen
all or some of the 4 screws on the wall
bracket to adjust the length.
Samsung Electronics
Captive Screws
Hinge (Left)
There are two hinges
(left and right). Use the
correct one.
Length between the
two locking holes
Wall Bracket
Hinge (Right)
3
Check the installation diagram and mark
the drill points on the wall.
Use the 5.0 mm bit to drill holes deeper
than 35 mm. Fix each anchor in the
corresponding hole.
Match each of the brackets and hinge
holes to the corresponding anchor holes
and insert and tighten the 11 screws .
Operation Instruction & Installation
11-9
Advertisement
Troubleshooting
