Table of Contents
Advertisement
Figure 91
1. 7.6 cm (3 inches) at
position A is correct.
2. 8.3 cm (3-1/4 inches) at
position B is correct.
9.
If needed, loosen the whizlock nut on the side
of the yoke and the jam nut on top. Fine-tune
the screw adjuster by turning it to get 7.6 cm (3
inches) height (see
Note:
To increase the height, turn the adjuster
screw clockwise; to decrease the height, turn it
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can utilize the single-point adjustment to gain
more adjustment.
3. Measure here from the
blade tip to the hard
surface.
4. Measure at position A and
B on both sides.
Figure
92).
g024245
1. Whizlock nut
2. Adjuster screw
10.
To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure
94).
Note:
The mower deck is attached in the
back holes at the factory. Refer to
93. If needed, use the front holes for further
adjustment when leveling the mower deck.
1. Mower deck
2. Front hole
65
Figure 92
3. Jam nut
4. Yoke
Figure
Figure 93
3. Back hole
g027410
g025558
Advertisement
Table of Contents
