Table of Contents
Advertisement
+
Water softening
system / special salt
To ensure good rinsing results, the
l t
s y s t e m / s p e c i a l s a
W a t e r s o f t e n i n g
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l) must
be softened. The water is softened with
special salt (regeneration salt) in the
water softening system
of the dishwasher. The setting and
therefore the required amount of salt
depends on the degree of hardness of
your tap water (see following water
hardness table).
Water hardness table
Water softening system/special salt en
Adjusting the water softening
system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not required
at the set value 0-8.
Set the softening system as follows:
Ask your local water utility company
1.
for the water hardness value of the
tap water.
Required setting can be found in the
2.
water hardness table.
Open the door.
3.
Switch on ON/OFF switch (.
4.
Press Info button { 8 for 3
5.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
Keep pressing button > )R until the
6.
water hardness is indicated on the
display window at the top @.
Make the setting with setting buttons
7.
+ - X.
Press and hold the Info button {
8.
8 for 3 seconds.
The chosen setting has now been
stored.
19
Advertisement
Table of Contents
