Table of Contents
Advertisement
en Troubleshooting
Fault
Water marks on
plastic parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Tea residue or lipstick
marks on tableware.
46
Cause and troubleshooting
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
Select a more intensive programme.
▶
Position tableware at an angle.
▶
→ "Arrange tableware", Page 31
Use rinse aid.
▶
→ "Rinse aid", Page 26
Set the water softening system higher.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent.
▶
Clean the appliance mechanically.
▶
White coating is deposited in the appliance interior.
Set the water softening system correctly.
1.
In most cases you will need to increase the setting.
Change your detergent if required.
2.
Special salt dispenser is not screwed tight.
Screw the special salt dispenser tight.
▶
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
Change your detergent.
▶
Clean the appliance mechanically.
▶
Hardness range is set incorrectly or the water hard-
ness is too high.
Set the Water softening system → Page 24 to the
▶
water hardness or add special salt.
3in1/organic/eco detergent is not effective enough.
Set the Water softening system → Page 24 to the
▶
water hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Too little detergent is being used.
Increase the amount of detergent used or change
▶
Detergent .
Washing programme selected too weak.
Select a more intensive washing programme.
▶
Washing temperature is too low.
Select a programme with a higher washing temper-
▶
ature.
Too little detergent is being used or is unsuitable.
Advertisement
Table of Contents
