Configuring Mvr On Access Ports - Cisco ME 3400 Software Configuration Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages) ,
- Getting started manual (33 pages)
Table of Contents
Advertisement
Configuring MVR
Command
Step 7
end
Step 8
show mvr or show mvr members
Step 9
copy running-config
startup-config
To return the switch to its default settings, use the no mvr [mode | group ip-address | querytime | vlan]
global configuration commands.
This example shows how to enable MVR, configure the group address, set the query time to 1 second
(10 tenths), specify the MVR multicast VLAN as VLAN 22, and set the MVR mode as dynamic:
Switch(config)# mvr
Switch(config)# mvr group 228.1.23.4
Switch(config)# mvr querytime 10
Switch(config)# mvr vlan 22
Switch(config)# mvr mode dynamic
Switch(config)# end
You can use the show mvr members privileged EXEC command to verify the MVR multicast group
addresses on the switch.
Configuring MVR on Access Ports
For more information about access and trunk ports, see
Note
Beginning in privileged EXEC mode, follow these steps to configure Layer 2 MVR interfaces on access
ports:
Command
Step 1
configure terminal
Step 2
mvr
Step 3
interface interface-id
Step 4
no shutdown
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
21-20
Purpose
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable MVR on the switch.
Specify the Layer 2 port to configure, and enter interface configuration
mode.
Enable the port, if necessary. By default, UNIs and ENIs are disabled, and
NNIs are enabled.
Chapter 21
Configuring IGMP Snooping and MVR
Chapter 9, "Configuring
Interfaces".
OL-9639-07
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
