Table of Contents
Advertisement
Analog Modem WAN Interface Cards
intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and
require isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring.
Connect one end of a straight-through RJ-11-to-RJ-11 cable to the pink RJ-11 port labeled LINE on the
Step 2
analog modem WIC.
Connect the other end of the cable to a wall telephone outlet, as shown in
Step 3
Figure 106
Depending on whether you have a 1-port or 2-port analog modem WIC:
Step 4
• For 1-port analog modem WICs, you can connect an analog telephone to the RJ-11 port labeled
• For 2-port analog modem WICs repeat
Turn on power to the router.
Step 5
Related Documentation
Related documentation is available on Cisco.com. For more information, see the
Documentation, Obtaining Support, and Security Guidelines" section on page
•
•
•
•
•
•
Connecting an Analog Modem WIC to a Wall Telephone Outlet
Analog modem port (RJ-11)
Straight-through
RJ-11 cable
RJ-11 jack
PHONE. This allows the dialout line to be shared between the telephone and the modem.
1- and 2-Port V.90 Modem WICs for Cisco 2600 and Cisco 3600 Series Multiservice
Cisco IOS Release 12.2(8)T feature module
AT Command Set and Register Summary for V.90 WIC-1AM and WIC-2AM Analog Modem WAN
Interface Cards
Analog Modem Interface Card Configuration Notes for Cisco 1700 Series Routers
Cisco Network Modules and Interface Cards Regulatory Compliance and Safety Information
Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
Modem-Router Connection
Step 2
and
Step 3
Guide, tech note
Related Documentation
Figure
106.
to connect the second port to a network.
"Obtaining
6.
OL-12848-01
Platforms,
5
Hide quick links:
Advertisement
Chapters
Table of Contents
