Table of Contents
Advertisement
Configuring 1-Port ADSL WAN Interface Card
Command
Step 7
Router(config-if-vc)#
encapsulation {aal2 |
aal5ciscoppp | aal5mux |
aal5nlpid | aal5snap}
Step 8
Router(config-if-vc)# exit
Step 9
Router(config-if)# dsl
operating-mode {ansi-dmt |
auto | itu-dmt |
splitterless}
Step 10
Router(config-if)# no
shutdown
Step 11
Router(config-if)# exit
Step 12
Router(config)# exit
Step 13
Router# show interface atm
1/0
Verifying ATM Configuration
Use the following commands to verify configuration:
•
•
•
•
•
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-32
To verify current configuration and to view the status for all controllers, use the show
running-config command.
To view ATM controller statistics, use the show controllers atm slot/port command.
To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.
To help identify ATM-related events as they are generated, use the debug atm events command.
To indicate what interfaces are having trouble, use the debug atm errors command.
To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port
you configured, use the show ip route command.
To display the configured list of ATM static maps to remote hosts on an ATM network, use the show
atm map command.
Chapter 3
Purpose
(Optional) Configure the ATM adaptation layer (AAL) and
encapsulation type.
•
aal2—AAL2
•
aal5ciscoppp—Cisco PPP over AAL5
•
aal5mux—AAL5+MUX
•
aal5nlpid—AAL5+NLPID
aal5snap—AAL5+LLC/SNAP (the default)
•
Exit from interface-atm-vc configuration mode.
Configure the ADSL interface to operate in a specified
mode:
ansi-dmt—ANSI full rate mode per T1.413 (ITU
•
G.DMT Issue 1)
auto—Automatic detection mode
•
itu-dmt—ITU full rate mode (ITU G.DMT Issue 1)
•
splitterless—G.lite mode per ITU G.992.2
•
This command is for testing or lab environments
Caution
only. Using a configuration other than the
default configuration for the DSL operating
mode can lead to unpredictable behavior on the
ADSL line.
Activate the ATM interface.
Exit from ATM interface configuration mode.
Exit from global configuration mode.
Verify the ATM interface configuration.
Configuring with the Command-Line Interface
OL-1957-03
Hide quick links:
Advertisement
Table of Contents
