Table of Contents
Advertisement
ip igmp snooping vlan static
ip igmp snooping vlan static
To add a Layer 2 port as a member of a multicast group, use the ip igmp snooping vlan vlan-id static
command in global configuration mode. To remove the configuration, use the no form of this command.
Syntax Description
vlan vlan-id
static mac-address
interface interface-id
Defaults
No Layer 2 ports are configured.
Command Modes
Global configuration
Command History
Release
12.0(5.2)WC(1)
12.2(15)ZJ
Usage Guidelines
The command is used to statically configure the IP multicast group member ports.
The static ports and groups are saved in nonvolatile RAM (NVRAM).
Static connections to multicast routers are supported only on switch ports.
Examples
The following example shows how to statically configure a host on an interface:
Switch(config)# ip igmp snooping vlan 1 static 0100.5e02.0203 interface fastethernet0/6
Configuring port FastEthernet 0/6 on group 0100.5e02.0203
You can verify your settings by entering the show mac-address-table multicast privileged EXEC
command.
Related Commands
Command
ip igmp snooping
ip igmp snooping vlan
ip igmp snooping vlan
immediate-leave
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
194
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
ip igmp snooping vlan vlan-id static mac-address interface interface-id
no ip igmp snooping vlan vlan-id static mac-address interface interface-id
Modification
This command was introduced.
This command was implemented on the following platforms: Cisco 2600
series, Cisco 3600 series, and Cisco 3700 series routers.
Specifies the VLAN ID. The range is 1 to 1001. Do not enter
leading zeroes.
Specifies the static group MAC address.
Specifies the interface configured to a static router port.
Description
Enables IGMP snooping.
Enables IGMP snooping on the VLAN interface.
Configures IGMP Immediate-Leave processing.
Hide quick links:
Advertisement
Chapters
Table of Contents
