Prerequisites
•
•
•
•
•
•
•
To obtain lists of supported MIBs by platform and Cisco IOS release, and to download MIB modules,
go to the Cisco MIB website on Cisco.com at the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
RFCs
•
Prerequisites
•
•
In addition, complete the following tasks before configuring this feature:
•
•
Configuration Tasks
See the following sections for configuration tasks for the Ethernet switch network module.
•
•
•
•
•
•
•
•
•
•
•
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
46
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
IPMROUTE-MIB
CISCO-MEMORY-POOL-MIB
ETHER-LIKE-MIB (RFC 1643)
CISCO-ENTITY-FRU-CONTROL-MIB.my
CISCO-RTTMON-MIB
CISCO-PROCESS-MIB
CISCO-COPS-CLIENT-MIB
RFC 2284, PPP Extensible Authentication Protocol (EAP)
Cisco IOS Release 12.2 or later release
Basic configuration of the Cisco 2600 series, Cisco 3600 series, or Cisco 3700 series router
Configure IP routing
For more information on IP routing, refer to the Cisco IOS IP Configuration Guide, Release 12.2.
Set up the call agents
For more information on setting up call agents, refer to the documentation that accompanies the call
agents used in your network configuration.
Configuring Layer 2 Interfaces, page 47
Configuring VLANs, page 52
Configuring VLAN Trunking Protocol, page 54
Configuring Layer 2 EtherChannels (Port-Channel Logical Interfaces), page 56
Configuring 802.1x Authentication, page 59
Configuring Spanning Tree, page 67
Configuring MAC Table Manipulation — Port Security, page 72
Configuring Cisco Discovery Protocol, page 74
Configuring Switched Port Analyzer, page 76
Configuring Network Security with ACLs, page 78
Configuring Quality of Service (QoS), page 86