Table of Contents
Advertisement
Configuring the Voice Interface
To configure the voice interface configuration mode, follow this procedure:
Connect a console to the Cisco VG224. If you need instructions for connecting a console, refer to the
Step 1
installation chapter of your Cisco VG224 installation and configuration guide.
Power on the Cisco VG224. If the current configuration is no longer valid, after about one minute you
Step 2
see the following prompt:
Would you like to enter the initial dialog? [yes/no]:
Answer no. You now enter the normal operating mode of the Cisco VG224.
Note
After a few seconds, you see the user EXEC prompt (
Step 3
enable mode:
Router> enable
Password: < password >
Configuration changes can be made only in enable mode. The prompt changes to the privileged EXEC
(enable) prompt (
Router#
Step 4
Enter the configure terminal command to enter configuration mode:
Router# configure terminal
Router(config)#
The Cisco VG224 enters global configuration mode, indicated by the
If you have not configured the Cisco VG224 before, or want to change the configuration, use Cisco IOS
Step 5
commands to configure global parameters, passwords, network management, and routing protocols. In
this example, IP routing is enabled:
Router(config)# ip routing
For complete information about global configuration commands, refer to the Cisco IOS configuration
guides and command references.
If you have not already done so, configure the network module or WAN interface card that you plan to
Step 6
use for IP traffic. For instructions, see your Cisco VG224's hardware installation and software
configuration guides or the configuration note for the network module or WAN interface card.
Step 7
To configure another interface, enter the exit command to return to the
Step 8
To configure the Cisco VG224 for voice traffic, refer to the VoIP references in
When you finish configuring interfaces, exit configuration mode and return to the enable prompt by
Step 9
pressing Ctrl-Z. To see the current operating configuration, including any changes you just made, enter
the show running-config command:
Router# show running-config
To see the configuration currently stored in NVRAM, enter the show startup-config command at the
enable prompt:
Router# show startup-config
Cisco VG224 Voice Gateway Software Configuration Guide
4-2
If the current configuration is valid, you enter the normal operating mode automatically.
):
Router#
Chapter 4
). Type enable and the password to enter
Router>
Router(config)#
Router(config)#
Prerequisites, page
Configuring Voice over IP
prompt.
prompt.
4-1.
OL-5005-01
Advertisement
Table of Contents
