Table of Contents
Advertisement
Chapter 31
Configuring Network Security with ACLs
•
•
•
If IEEE 802.1Q tunneling is configured on an interface, any IEEE 802.1Q encapsulated IP packets
received on the tunnel port can be filtered by MAC ACLs, but not by IP ACLs. This is because the switch
does not recognize the protocol inside the IEEE 802.1Q header. This restriction applies to router ACLs,
port ACLs, and VLAN maps. For more information about IEEE 802.1Q tunneling, see
"Configuring IEEE 802.1Q Tunneling"
Protocol Tunneling."
Port ACLs
Port ACLs are ACLs that are applied to Layer 2 interfaces on a switch. Port ACLs are supported only on
physical interfaces and not on EtherChannel interfaces and can be applied only on interfaces in the
inbound direction. These access lists are supported:
•
•
•
The switch examines ACLs associated with all inbound features configured on a given interface and
permits or denies packet forwarding based on how the packet matches the entries in the ACL. In this way,
ACLs control access to a network or to part of a network.
to control access to a network when all servers are in the same VLAN. ACLs applied at the Layer 2 input
would allow Blade Server A to access the Human Resources network, but prevent Blade Server B from
accessing the same network. Port ACLs can only be applied to Layer 2 interfaces in the inbound
direction.
OL-8915-03
When an output router ACL and input port ACL exist in an SVI, incoming packets received on the
ports to which a port ACL is applied are filtered by the port ACL. Outgoing routed IP packets are
filtered by the router ACL. Other packets are not filtered.
When a VLAN map, input router ACL, and input port ACL exist in an SVI, incoming packets
received on the ports to which a port ACL is applied are only filtered by the port ACL. Incoming
routed IP packets received on other ports are filtered by both the VLAN map and the router ACL.
Other packets are filtered only by the VLAN map.
When a VLAN map, output router ACL, and input port ACL exist in an SVI, incoming packets
received on the ports to which a port ACL is applied are only filtered by the port ACL. Outgoing
routed IP packets are filtered by both the VLAN map and the router ACL. Other packets are filtered
only by the VLAN map.
Standard IP access lists using source addresses
Extended IP access lists using source and destination addresses and optional protocol type
information
MAC extended access lists using source and destination MAC addresses and optional protocol type
information
and
Chapter 15, "Configuring IEEE 802.1Q and Layer 2
Figure 31-1
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Understanding ACLs
Chapter 15,
is an example of using port ACLs
31-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
