Table of Contents
Advertisement
Configuring RIP
Command
Step 10
no validate-update-source
Step 11
output-delay delay
Step 12
end
Step 13
show ip protocols
Step 14
copy running-config startup-config
To turn off the RIP routing process, use the no router rip global configuration command.
To display the parameters and current state of the active routing protocol process, use the show ip
protocols privileged EXEC command. Use the show ip rip database privileged EXEC command to
display summary address entries in the RIP database.
Configuring RIP Authentication
RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2 packets,
you can enable RIP authentication on an interface. The key chain specifies \the set of keys that can be
used on the interface. If a key chain is not configured, no authentication is performed, not even the
default. Therefore, you must also perform the tasks in the
page
The switch supports two modes of authentication on interfaces for which RIP authentication is enabled:
plain text and MD5. The default is plain text.
Beginning in privileged EXEC mode, follow these steps to configure RIP authentication on an interface:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
ip rip authentication key-chain name-of-chain
Step 4
ip rip authentication mode [text | md5}
Step 5
end
Step 6
show running-config interface [interface-id]
Step 7
copy running-config startup-config
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
34-20
Purpose
(Optional) Disable validation of the source IP address of incoming RIP
routing updates. By default, the switch validates the source IP address of
incoming RIP routing updates and discards the update if the source
address is not valid. Under normal circumstances, disabling this feature
is not recommended. However, if you have a router that is off-network
and you want to receive its updates, you can use this command.
(Optional) Add interpacket delay for RIP updates sent.
By default, packets in a multiple-packet RIP update have no delay added
between packets. If you are sending packets to a lower-speed device, you
can add an interpacket delay in the range of 8 to 50 milliseconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
34-36.
Chapter 34
"Managing Authentication Keys" section on
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the
interface to configure.
Enable RIP authentication.
Configure the interface to use plain text authentication (the
default) or MD5 digest authentication.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring IP Unicast Routing
OL-8915-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
