Table of Contents
Advertisement
Configuring IPv6 ACLs
This chapter includes information about configuring IPv6 ACLs on the switch. You can create and apply
input IPv6 router ACLs to filter incoming IPv6 management traffic.
To use IPv6, you must configure the dual IPv4 and IPv6 Switch Database Management (SDM) template
Note
on the switch. You select the template by entering the sdm prefer dual-ipv4-and-ipv6 {default |
routing | vlan} global configuration command.
For related information, see these chapters:
•
•
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release or the Cisco IOS documentation referenced in the procedures.
This chapter contains these sections:
•
•
•
Understanding IPv6 ACLs
The switch supports only input router IPv6 ACLs applied to all IPv6 management packets entering the
Layer 3 interface.
The switch does not support IPv6 port ACLs, output IPv6 router ACLs, or VLAN ACLs (VLAN maps)
for IPv6 traffic.
If you configure unsupported IPv6 ACLs, an error message appears and the configuration does not take
Note
affect.
For more information about ACL support on the switch, see
with ACLs."
OL-8915-03
For more information about SDM templates, see
For information about IPv6 on the switch, see
Understanding IPv6 ACLs, page 37-1
Configuring IPv6 ACLs, page 37-3
Displaying IPv6 ACLs, page 37-7
C H A P T E R
Chapter 6, "Configuring SDM Templates."
Chapter 35, "Configuring IPv6 Host Functions."
Chapter 31, "Configuring Network Security
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
37
37-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
