Using Ttl To Limit The Multicast Data Sent In Sa Messages; Controlling Source Information That Your Switch Receives - Cisco WS-C3560-48PS-S Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Hardware installation manual (120 pages)
Table of Contents
Advertisement
Configuring MSDP
Using TTL to Limit the Multicast Data Sent in SA Messages
You can use a TTL value to control what data is encapsulated in the first SA message for every source.
Only multicast packets with an IP-header TTL greater than or equal to the ttl argument are sent to the
specified MSDP peer. For example, you can limit internal traffic to a TTL of 8. If you want other groups
to go to external locations, you must send those packets with a TTL greater than 8.
Beginning in privileged EXEC mode, follow these steps to establish a TTL threshold. This procedure is
optional.
Command
Step 1
configure terminal
Step 2
ip msdp ttl-threshold {ip-address | name}
ttl
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup-config
To return to the default setting, use the no ip msdp ttl-threshold {ip-address | name} global
configuration command.
Controlling Source Information that Your Switch Receives
By default, the switch receives all SA messages that its MSDP RPF peers send to it. However, you can
control the source information that you receive from MSDP peers by filtering incoming SA messages.
In other words, you can configure the switch to not accept them.
You can perform one of these actions:
•
•
•
Catalyst 3560 Switch Software Configuration Guide
33-14
Filter all incoming SA messages from an MSDP peer
Specify an IP extended access list to pass certain source/group pairs
Filter based on match criteria in a route map
Purpose
Enter global configuration mode.
Limit which multicast data is encapsulated in the first SA message to
the specified MSDP peer.
•
For ip-address | name, enter the IP address or name of the MSDP
peer to which the TTL limitation applies.
•
For ttl, enter the TTL value. The default is 0, which means all
multicast data packets are forwarded to the peer until the TTL is
exhausted. The range is 0 to 255.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 33
Configuring MSDP
78-16156-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
