Cisco WS-C3560-48PS-S Software Configuration Manual page 761
Software configuration guide
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Hardware installation manual (120 pages)
Table of Contents
Advertisement
Chapter 33
Configuring MSDP
Command
Step 3
access-list access-list-number {deny |
permit} protocol source source-wildcard
destination destination-wildcard
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
To remove the filter, use the no ip msdp sa-filter out {ip-address | name} [list access-list-number]
[route-map map-tag] global configuration command.
This example shows how to allow only (S,G) pairs that pass access list 100 to be forwarded in an SA
message to the peer named switch.cisco.com:
Switch(config)# ip msdp peer switch.cisco.com connect-source gigabitethernet0/1
Switch(config)# ip msdp sa-filter out switch.cisco.com list 100
Switch(config)# access-list 100 permit ip 171.69.0.0 0.0.255.255 224.20 0 0.0.255.255
78-16156-01
Purpose
(Optional) Create an IP extended access list, repeating the command as
many times as necessary.
•
For access-list-number, enter the number specified in Step 2.
•
The deny keyword denies access if the conditions are matched. The
permit keyword permits access if the conditions are matched.
•
For protocol, enter ip as the protocol name.
•
For source, enter the number of the network or host from which the
packet is being sent.
•
For source-wildcard, enter the wildcard bits in dotted decimal
notation to be applied to the source. Place ones in the bit positions
that you want to ignore.
For destination, enter the number of the network or host to which
•
the packet is being sent.
For destination-wildcard, enter the wildcard bits in dotted decimal
•
notation to be applied to the destination. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3560 Switch Software Configuration Guide
Configuring MSDP
33-13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
