Replacing A Failed Command Switch With Another Switch - Cisco WS-C3560-48PS-S Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Hardware installation manual (120 pages)
Table of Contents
Advertisement
Recovering from a Command Switch Failure
Step 12
When prompted for the enable secret and enable passwords, enter the passwords of the failed command
switch again.
Step 13
When prompted, make sure to enable the switch as the cluster command switch, and press Return.
Step 14
When prompted, assign a name to the cluster, and press Return.
The cluster name can be 1 to 31 alphanumeric characters, dashes, or underscores.
Step 15
After the initial configuration displays, verify that the addresses are correct.
If the displayed information is correct, enter Y, and press Return.
Step 16
If this information is not correct, enter N, press Return, and begin again at Step 9.
Start your browser, and enter the IP address of the new command switch.
Step 17
From the Cluster menu, select Add to Cluster to display a list of candidate switches to add to the cluster.
Step 18
Replacing a Failed Command Switch with Another Switch
To replace a failed command switch with a switch that is command-capable but not part of the cluster,
follow these steps:
Insert the new switch in place of the failed command switch, and duplicate its connections to the cluster
Step 1
members.
Start a CLI session on the new command switch.
Step 2
You can access the CLI by using the console port or, if an IP address has been assigned to the switch, by
using Telnet. For details about using the console port, refer to the switch hardware installation guide.
At the switch prompt, enter privileged EXEC mode:
Step 3
Switch> enable
Switch#
Step 4
Enter the password of the failed command switch.
Use the setup program to configure the switch IP information.
Step 5
This program prompts you for IP address information and passwords. From privileged EXEC mode,
enter setup, and press Return.
Switch# setup
Continue with configuration dialog? [yes/no]: y
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:
Catalyst 3560 Switch Software Configuration Guide
35-10
--- System Configuration Dialog ---
Chapter 35
Troubleshooting
78-16156-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
