Table of Contents
Advertisement
Chapter 30
Configuring SNMP
Table 30-5 Switch Notification Types
Notification Type
Keyword
bgp
bridge
cluster
config
config-copy
entity
envmon
flash
fru-ctrl
hsrp
ipmulticast
mac-notification
msdp
pim
port-security
rtr
snmp
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
78-16180-02
Description
Generates BGP state change traps. This option is only available when the
enhanced multilayer image is installed.
Generates STP bridge MIB traps.
Generates a trap when the cluster configuration changes.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
Generates SNMP FLASH notifications. You can optionally enable
notification for flash insertion or removal, which would cause a trap to be
issued whenever a switch in the stack is removed or inserted (physical
removal, power cycle, or reload).
Generates entity FRU control traps. In the switch stack, this trap refers to the
insertion or removal of a switch in the stack.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Generates a trap for MAC address notifications.
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can
enable any or all of these traps: invalid PIM messages, neighbor changes, and
rendezvous point (RP)-mapping changes.
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Generates a trap for TCP connections. This trap is enabled by default.
Generates a trap for SNMP VLAN membership changes.
Generates SNMP VLAN created traps.
Generates SNMP VLAN deleted traps.
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table
30-5.
Catalyst 3750 Switch Software Configuration Guide
Configuring SNMP
30-13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
