Table of Contents
Advertisement
Chapter 6
Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
!Specifies the IP local pool to use for address assignment.
ip local pool pool1 192.168.0.1 192.168.0.100
Example 6-5
virtual-template 1 and the VPN_2 BBA group is associated with virtual-template 2. The VPN_1 group
is associated with VLAN 20 and the VPN_2 group is associated with VLAN 30.
Example 6-5
bba-group pppoe VPN_1
!
!
bba-group pppoe VPN_2
!
!
interface GigabitEthernet1/0/0.1
!
interface GigabitEthernet 2/0/0.2
Verifying PPPoE over Ethernet and IEEE 802.1Q VLAN
To verify PPPoE over Ethernet and IEEE 802.1Q VLAN, enter the following commands in privileged
EXEC mode:
Command
Router# show vpdn
Router# show vpdn session
Router# show vpdn session packet
Router# show vpdn session all
Router# show vpdn tunnel
Router# show pppoe session all
Router# show pppoe session packets
OL-2226-23
peer default ip address pool pool1
ppp authentication chap
creates two BBA groups: VPN_1 and VPN_2. The VPN_1 BBA group is associated with
Using a BBA Group to Configure PPPoE over IEEE 802.1Q VLANs
virtual-template 1
sessions per-vc limit 5
sessions per-mac limit 10
sessions per-vlan limit 5
virtual-template 2
sessions per-vc limit 5
sessions per-mac limit 10
sessions per-vlan limit 5
encapsulation dot1q 20
protocol pppoe group VPN_1
encapsulation dot1q 30
protocol pppoe group VPN_2
Purpose
Displays information about active Level 2 Forwarding (L2F)
Protocol tunnel and message identifiers in a VPDN.
Displays information about active Layer 2 Tunnel Protocol
(L2TP) or Layer 2 Forwarding (L2F) sessions in a VPDN.
Displays PPPoE session statistics.
Displays PPPoE session information for each session ID.
Displays PPPoE session count for the tunnel.
Displays PPPoE session information for each session ID.
Displays PPPoE session statistics.
Cisco 10000 Series Router Software Configuration Guide
PPPoE over IEEE 802.1Q VLANs
6-11
Advertisement
Table of Contents
Troubleshooting
