Table of Contents
Advertisement
PPPoE over Ethernet
Feature History for PPPoE over Ethernet
Cisco IOS Release
12.2(4)BZ1
12.3(7)XI1
12.2(28)SB
Restrictions for PPPoE over Ethernet
The PPPoE over Ethernet feature has the following restriction:
•
Note
Configuration Tasks for PPPoE over Ethernet
To configure the PPPoE over Ethernet feature, perform the following configuration tasks:
•
•
•
•
Configuring a Virtual Template Interface
Configure a virtual template before you configure PPPoE on an Ethernet interface. The virtual template
interface is a logical entity that is applied dynamically as needed to an incoming PPP session request.
To configure a virtual template interface, see the
page
Cisco 10000 Series Router Software Configuration Guide
6-2
Description
This feature was introduced on the Cisco 10000 series
router.
This feature was integrated into Cisco IOS Release
12.3(7)XI1.
This feature was integrated into Cisco IOS Release
12.2(28)SB.
The Cisco 10000 series router currently supports the PPPoE over Ethernet feature on Gigabit
Ethernet line cards and Fast Ethernet 8-port half-height line cards. The Fast Ethernet port of the
performance routing engine (PRE) does not support the PPPoE over Ethernet feature.
The Cisco 10000 series router supports a Fast Ethernet interface for management traffic only.
Configuring a Virtual Template Interface, page 6-2
Creating an Ethernet Interface and Enabling PPPoE, page 6-3
Configuring PPPoE in a VPDN Group, page 6-3
Configuring PPPoE in a BBA Group, page 6-3
3-17.
Chapter 6
Configuring PPPoE over Ethernet and IEEE 802.1Q VLAN
"Configuring a Virtual Template Interface" section on
Required PRE
PRE1
PRE2
PRE2
OL-2226-23
Advertisement
Table of Contents
Troubleshooting
