Table of Contents
Advertisement
Chapter 22
Configuring Multilink Point-to-Point Protocol Connections
Command
Step 1
Router(config)# interface atm
slot/module/port
Step 2
Router(config-if)# hold-queue length {in |
out}
Step 3
Router(config-if)# interface atm
slot/module/port.subinterface point-to-point
Step 4
Router(config-subif)# ppp chap hostname
hostname
Step 5
Router(config-subif)# no ip address
Step 6
Router(config-subif)# pvc [name] vpi/vci
Step 7
Router(config-if-atm-vc)# vbr-nrt output-pcr
output-scr output-mbs
OL-2226-23
Configuring MLP Bundles and Member Links
Purpose
Configures or modifies the ATM interface you specify and
enters interface configuration mode.
Limits the size of the IP output queue on an interface.
length is a number that specifies the maximum number of
packets in the queue. Valid values are from 0 to 4096. We
recommend 4096 packets for all line cards. By default, the
input queue is 75 packets and the output queue is 40 packets.
in specifies the input queue.
out specifies the output queue.
We recommend that you configure this command on
Note
all physical interfaces, except when using the ATM
OC-12 line card.
Creates or modifies a point-to-point subinterface. Enters
subinterface configuration mode.
(Optional) Identifies the hostname sent in the Challenge
Handshake Authentication Protocol (CHAP) challenge.
hostname is the name of the bundle group. This name
uniquely identifies the bundle.
If you configure this command on the bundle and its
Note
member links, specify the same identifier for both the
bundle and the member links.
Removes any existing IP address from the main interface.
Creates or modifies an ATM PVC. Enters ATM VC
configuration mode.
name is the name of the ATM PVC.
vpi/ is the virtual path identifier. If you do not specify a VPI
value and the slash character (/), the VPI value defaults to 0.
vci is the virtual channel identifier.
Configures the variable bit rate-nonreal time (VBR-nrt)
quality of service (QoS).
output-pcr is the output peak cell rate (PCR), in kbps.
output-scr is the sustainable cell rate (SCR), in kbps.
output-mbs is the output maximum burst cell size (MBS),
expressed in number of cells.
Cisco 10000 Series Router Software Configuration Guide
22-33
Advertisement
Table of Contents
Troubleshooting
