Table of Contents
Advertisement
Understanding Layer 2 Protocol Tunneling
Understanding Layer 2 Protocol Tunneling
Customers at different sites connected across a service-provider network need to use various Layer 2
protocols to scale their topologies to include all remote sites, as well as the local sites. STP must run
properly, and every VLAN should build a proper spanning tree that includes the local site and all remote
sites across the service-provider network. Cisco Discovery Protocol (CDP) must discover neighboring
Cisco devices from local and remote sites. VLAN Trunking Protocol (VTP) must provide consistent
VLAN configuration throughout all sites in the customer network that are participating in VTP.
The Cisco ME 3400 switch does not support VTP; CDP and STP are supported only on NNIs. However,
Note
Layer 2 protocol tunneling is supported on all ports on the switch.
When protocol tunneling is enabled, edge switches on the inbound side of the service-provider network
encapsulate Layer 2 protocol packets with a special MAC address and send them across the
service-provider network. Core switches in the network do not process these packets but forward them
as normal packets. Layer 2 protocol data units (PDUs) for CDP, STP, or VTP cross the service-provider
network and are delivered to customer switches on the outbound side of the service-provider network.
Identical packets are received by all customer ports on the same VLANs with these results:
•
•
•
Layer 2 protocol tunneling can be used independently or can enhance IEEE 802.1Q tunneling. If protocol
tunneling is not enabled on IEEE 802.1Q tunneling ports, remote switches at the receiving end of the
service-provider network do not receive the PDUs and cannot properly run STP, CDP, and VTP. When
protocol tunneling is enabled, Layer 2 protocols within each customer's network are totally separate
from those running within the service-provider network. Customer switches on different sites that send
traffic through the service-provider network with IEEE 802.1Q tunneling achieve complete knowledge
of the customer's VLAN. If IEEE 802.1Q tunneling is not used, you can still enable Layer 2 protocol
tunneling by connecting to the customer switch through access ports and by enabling tunneling on the
service-provider access port.
For example, in
through the service-provider network. If the network does not tunnel PDUs, switches on the far ends of
the network cannot properly run STP, CDP, and VTP. For example, STP for a VLAN on a switch in
Customer X, Site 1, will build a spanning tree on the switches at that site without considering
convergence parameters based on Customer X's switch in Site 2. This could result in the topology shown
in
Figure
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
13-8
Users on each of a customer's sites can properly run STP, and every VLAN can build a correct
spanning tree based on parameters from all sites and not just from the local site.
CDP discovers and shows information about the other Cisco devices connected through the
service-provider network.
VTP provides consistent VLAN configuration throughout the customer network, propagating to all
switches through the service provider that support VTP.
Figure
13-4, Customer X has four switches in the same VLAN, that are connected
13-5.
Chapter 13
Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
78-17058-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
