Table of Contents
Advertisement
Chapter 14
Configuring STP
Beginning in privileged EXEC mode, follow these steps to configure the port priority of an NNI. This
procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
spanning-tree port-priority priority
Step 4
spanning-tree vlan vlan-id port-priority priority
Step 5
end
Step 6
show spanning-tree interface interface-id
or
show spanning-tree vlan vlan-id
Step 7
copy running-config startup-config
Note
The show spanning-tree interface interface-id privileged EXEC command displays information only
if the port is in a link-up operative state. Otherwise, you can use the show running-config interface
privileged EXEC command to confirm the configuration.
To return to the default spanning-tree setting, use the no spanning-tree [vlan vlan-id] port-priority
interface configuration command. For information on how to configure load sharing on trunk ports by
using spanning-tree port priorities, see the
page
78-17058-01
11-19.
Purpose
Enter global configuration mode.
Specify an interface to configure, and enter interface
configuration mode.
Valid interfaces include physical NNIs and port-channel
logical interfaces (port-channel port-channel-number)
that contain only NNIs. If a physical interface is not an
NNI, enter the port-type nni interface configuration
command to make it an NNI before configuring spanning
tree.
Configure the port priority for an NNI.
For priority, the range is 0 to 240, in increments of 16; the
default is 128. Valid values are 0, 16, 32, 48, 64, 80, 96,
112, 128, 144, 160, 176, 192, 208, 224, and 240. All other
values are rejected. The lower the number, the higher the
priority.
Configure the port priority for a VLAN.
For vlan-id, you can specify a single VLAN identified
•
by VLAN ID number, a range of VLANs separated by
a hyphen, or a series of VLANs separated by a comma.
The range is 1 to 4094.
•
For priority, the range is 0 to 240, in increments of 16;
the default is 128. Valid values are 0, 16, 32, 48, 64, 80,
96, 112, 128, 144, 160, 176, 192, 208, 224, and 240.
All other values are rejected. The lower the number,
the higher the priority.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
"Configuring Trunk Ports for Load Sharing" section on
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring Spanning-Tree Features
14-17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
