Table of Contents
Advertisement
Configuring SNMP
Command
Step 6
snmp-server enable traps
notification-types
Step 7
snmp-server trap-source interface-id
Step 8
snmp-server queue-length length
Step 9
snmp-server trap-timeout seconds
Step 10
end
Step 11
show running-config
Step 12
copy running-config startup-config
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
informs). To enable a host to receive an inform, you must configure an snmp-server host informs
command for the host and globally enable informs by using the snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
informs, to the host. To disable informs, use the no snmp-server host informs global configuration
command. To disable a specific trap type, use the no snmp-server enable traps notification-types global
configuration command.
Setting the Agent Contact and Location Information
Beginning in privileged EXEC mode, follow these steps to set the system contact and location of the
SNMP agent so that these descriptions can be accessed through the configuration file:
Command
Step 1
configure terminal
Step 2
snmp-server contact text
Step 3
snmp-server location text
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
27-14
Purpose
Enable the switch to send traps or informs and specify the type of
notifications to be sent. For a list of notification types, see
page
27-12, or enter snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate snmp-server
enable traps command for each trap type.
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
informs.
(Optional) Establish the message queue length for each trap host. The
range is 1 to 1000; the default is 10.
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Set the system contact string.
For example:
snmp-server contact Dial System Operator at beeper 21555.
Set the system location string.
For example:
snmp-server location Building 3/Room 222
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 27
Configuring SNMP
Table 27-5 on
78-17058-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
