Table of Contents
Advertisement
Chapter 32
Configuring IP Unicast Routing
These sections contain this configuration information:
•
•
•
•
Default RIP Configuration
Table 32-4
Table 32-4
Feature
Auto summary
Default-information originate
Default metric
IP RIP authentication key-chain
IP RIP receive version
IP RIP send version
IP RIP triggered
IP split horizon
Neighbor
Network
Offset list
Output delay
Timers basic
Validate-update-source
Version
Configuring Basic RIP Parameters
To configure RIP, you enable RIP routing for a network and optionally configure other parameters.
78-17058-01
Default RIP Configuration, page 32-19
Configuring Basic RIP Parameters, page 32-19
Configuring RIP Authentication, page 32-21
Configuring Summary Addresses and Split Horizon, page 32-21
shows the default RIP configuration.
Default RIP Configuration
Default Setting
Enabled.
Disabled.
Built-in; automatic metric translations.
No authentication.
Authentication mode: clear text.
According to the version router configuration command.
According to the version router configuration command.
According to the version router configuration command.
Varies with media.
None defined.
None specified.
Disabled.
0 milliseconds.
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
•
Enabled.
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring RIP
32-19
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
