Table of Contents
Advertisement
Configuring EIGRP
Configuring EIGRP Interfaces
Other optional EIGRP parameters can be configured on an interface basis.
Beginning in privileged EXEC mode, follow these steps to configure EIGRP interfaces:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
no shutdown
Step 4
ip bandwidth-percent eigrp percent
Step 5
ip summary-address eigrp
autonomous-system-number address mask
Step 6
ip hello-interval eigrp autonomous-system-number
seconds
Step 7
ip hold-time eigrp autonomous-system-number
seconds
Step 8
no ip split-horizon eigrp autonomous-system-number (Optional) Disable split horizon to allow route information
Step 9
end
Step 10
show ip eigrp interface
Step 11
copy running-config startup-config
Use the no forms of these commands to disable the feature or return the setting to the default value.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
32-36
Chapter 32
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
Enable the interface if necessary. By default, UNIs are
disabled and NNIs are enabled.
(Optional) Configure the percentage of bandwidth that can
be used by EIGRP on an interface. The default is 50 percent.
(Optional) Configure a summary aggregate address for a
specified interface (not usually necessary if auto-summary is
enabled).
(Optional) Change the hello time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 60 seconds for low-speed NBMA networks and 5
seconds for all other networks.
(Optional) Change the hold time interval for an EIGRP
routing process. The range is 1 to 65535 seconds. The
default is 180 seconds for low-speed NBMA networks and
15 seconds for all other networks.
Caution
Do not adjust the hold time without consulting
Cisco technical support.
to be advertised by a router out any interface from which that
information originated.
Return to privileged EXEC mode.
Display which interfaces EIGRP is active on and
information about EIGRP relating to those interfaces.
(Optional) Save your entries in the configuration file.
Configuring IP Unicast Routing
78-17058-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
