Table of Contents
Advertisement
Configuring IP Multicast Routing
Command
Step 5
show running-config
Step 6
copy running-config startup-config
To remove an RP address, use the no ip pim rp-address ip-address [access-list-number] [override]
global configuration command.
This example shows how to configure the address of the RP to 147.106.6.22 for multicast
group 225.2.2.2 only:
Switch(config)# access-list 1 permit 225.2.2.2 0.0.0.0
Switch(config)# ip pim rp-address 147.106.6.22 1
Configuring Auto-RP
Auto-RP uses IP multicast to automate the distribution of group-to-RP mappings to all Cisco routers and
multilayer switches in a PIM network. It has these benefits:
•
•
•
If you configure PIM in sparse mode or sparse-dense mode and do not configure Auto-RP, you must
Note
manually configure an RP as described in the
on page
If routed interfaces are configured in sparse mode, Auto-RP can still be used if all devices are configured
Note
with a manual RP address for the Auto-RP groups.
These sections describe how to configure Auto-RP:
•
•
•
•
For overview information, see the
Setting up Auto-RP in a New Internetwork
If you are setting up Auto-RP in a new internetwork, you do not need a default RP because you configure
all the interfaces for sparse-dense mode. Follow the process described in the
Existing Sparse-Mode Cloud" section on page
PIM router as the RP for the local group.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
34-12
Purpose
Verify your entries.
(Optional) Save your entries in the configuration file.
It is easy to use multiple RPs within a network to serve different group ranges.
It provides load splitting among different RPs and arrangement of RPs according to the location of
group participants.
It avoids inconsistent, manual RP configurations on every router and multilayer switch in a PIM
network, which can cause connectivity problems.
34-11.
Setting up Auto-RP in a New Internetwork, page 34-12
Adding Auto-RP to an Existing Sparse-Mode Cloud, page 34-13
Preventing Join Messages to False RPs, page 34-14
Filtering Incoming RP Announcement Messages, page 34-15
"Manually Assigning an RP to Multicast Groups" section
(optional)
(optional)
"Auto-RP" section on page
34-13. However, omit Step 3 if you want to configure a
Chapter 34
Configuring IP Multicast Routing
(optional)
(optional)
34-4.
"Adding Auto-RP to an
78-17058-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
