Table of Contents
Advertisement
Recovering from a Lost or Forgotten Password
At the switch prompt, enter privileged EXEC mode:
Step 7
Switch> enable
Rename the configuration file to its original name:
Step 8
Switch# rename flash:config.text.old flash:config.text
Copy the configuration file into memory:
Step 9
Switch# copy flash:config.text system:running-config
Source filename [config.text]?
Destination filename [running-config]?
Press Return in response to the confirmation prompts.
The configuration file is now reloaded, and you can change the password.
Enter global configuration mode:
Step 10
Switch# configure terminal
Change the password:
Step 11
Switch (config)# enable secret password
The secret password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, and allows spaces but ignores leading spaces.
Return to privileged EXEC mode:
Step 12
Switch (config)# exit
Switch#
Write the running configuration to the startup configuration file:
Step 13
Switch# copy running-config startup-config
The new password is now in the startup configuration.
Note
Reload the switch:
Step 14
Switch# reload
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
36-6
This procedure is likely to leave your switch virtual interface in a shutdown state. You can
identify this interface by entering the show running-config privileged EXEC command. To
re-enable the interface, enter the interface vlan vlan-id global configuration command, and
specify the VLAN ID of the shutdown interface. With the switch in interface configuration
mode, enter the no shutdown command.
Chapter 36
Troubleshooting
78-17058-01
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
