Cisco SFS-7012 - SFS InfiniBand Server Switch 7012 Hardware User's Manual page 79
Server switch
Hide thumbs
Also See for SFS-7012 - SFS InfiniBand Server Switch 7012:
- Hardware user's manual (176 pages)
Table of Contents
Advertisement
Chapter
The combination of the Transport Domain and the Transport Address determines the trap destination.
Note
Port
•
Specifies the TCP port which the SNMP trap will be sent.
Timeout
•
Specifies the time that the trap sender waits on a response before re-sending the trap.
Retry Count
•
Specifies the number of attempts to be made to send the trap after a timeout condition occurs.
Timeout and Retry Count are SNMP v2.c and above. Not applicable for v1 traps.
Note
Tag List
•
Specifies which traps should be sent to this particular destination.
RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag List specifies that the trap
Note
receiver will get link up/down traps.
Parameters
•
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of
SNMP to use.
Storage Type
•
This field determines whether or not the entry is saved for each reboot of the SFS 7012.
–
–
Status
•
Indicates the current status of the row. The row may be in one of three states:
–
–
–
A status of not in service indicates that the current row will not be used in the event a trap is generated
Note
by the system. Toggling a trap to not in service, which temporarily suspends trap forwarding, may be
useful to keep values intact.
SNMP Target Parameters:
•
Parameter Name
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of
SNMP to use.
MP Model
•
The Message Processing Model to be used when generating SNMP messages for entry.
OL-8787-04
Nonvolatile means that the value is saved, and remains with each subsequent reboot.
Volatile or Other indicates it will not be saved.
Active
Not in service
Not Ready
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
61
Advertisement
Table of Contents
