Table of Contents
Advertisement
Chapter 2
Preparing for Router Installation
Required Tools and Equipment for Installation and Maintenance
You need the following tools and equipment for installing and upgrading the router and its components:
•
•
•
•
•
In addition, depending on the type of modules that you plan to use, you might need the following
equipment to connect a port to an external network:
•
•
•
•
•
•
•
OL-19084-02
ESD-preventive cord and wrist strap
Number 2 Phillips screwdriver for installing or removing modules, and a flat-blade screwdriver for
removing Compact Flash cover, upgrading memory, or other components: small, 3/16-inch (0.48
centimeter) and medium, 1/4-inch (0.63 centimeter).
A 1/4-inch (0.63 centimeter) nut driver
Wire crimper
AWG 14 wire for connecting the router chassis to earth ground
Cables for connection to WAN and LAN ports (dependent on configuration)
For more information on cable specifications, refer to
Note
Specifications.
Ethernet hub or PC with a network interface card for connection to Ethernet (LAN) ports
Console terminal (an ASCII terminal or a PC running terminal emulation software) configured for
9600 baud, 8 data bits, no parity, and 1 stop bit
Modem for connection to the auxiliary port for remote administrative access
Data service unit (DSU) or channel service unit/data service unit (CSU/DSU) as appropriate for
serial interfaces
External CSU for any CT1/PRI modules without a built-in CSU
NT1 device for ISDN BRI S/T interfaces (if not supplied by your service provider)
Required Tools and Equipment for Installation and Maintenance
Cisco Modular Access Router Cable
Cisco 1900 Series Hardware Installation
2-7
Hide quick links:
Advertisement
Table of Contents
