Table of Contents
Advertisement
Chapter 6
Circuits and Tunnels
Table 6-2
Step
1
2
3
4
5
6
Procedure: Create a J1 Path Trace
To perform this procedure, you must have an STS circuit using a DS-1, DS3E, or DS3XM card at the
circuit source and drop ports, or an STS circuit passing through an EC-1, OC-3, OC-48AS, or OC-192
card.
Log into the circuit source node and select the Circuits tab.
Step 1
Select the circuit you want to trace, then click Edit.
Step 2
On the Edit Circuit window, click Show Detailed Map at the bottom of the window.
Step 3
Step 4
On the detailed circuit map, right-click the source port for the circuit and select Edit Path Trace from
the shortcut menu.
November 2001
Path Trace Source and Drop Provisioning
Port
Action
Source Edit the path-trace transmit string. If not edited, an empty string is transmitted.
Drop
Edit the path-trace transmit string. If not edited, an empty string is transmitted.
Source Edit the path-trace expected
string.
Drop
Edit the path-trace expected string Only Path Trace mode is set to Manual, and only
Drop
Change Path Trace Mode
Source Change Path Trace Mode
Figure 6-7
shows an example.
Notes
Only if Path Trace mode is set to Manual, and only
on DS-1, DS3E, and DS3XM cards.
on DS-1, DS3E, and DS3XM cards.
Automatic or Manual.
Automatic or Manual.
Cisco ONS 15454 Installation and Operations Guide
Creating a Path Trace
6-13
Advertisement
Table of Contents
