Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 193
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Chapter 3
Installing the Switch
Figure 3-42
CAB-INF-28G-5
Installing and Cabling 10GBASE-X X2 Transceiver Uplink Ports
The 10-Gigabit X2 transceiver can have either a spring-loaded latch sleeve or a latch sleeve that is not
spring loaded. Both transceiver types are functionally identical.
Caution
The X2 transceiver is a static-sensitive device. Always use an ESD wrist strap or similar individual
grounding device when handling X2 transceivers or coming in contact with system modules.
To install an X2 transceiver uplink port, follow these steps:
Using a small flat-blade screwdriver, carefully pry the X2 transceiver port cover off of the supervisor
Step 1
engine faceplate.
Use the two arrows on the port cover as guides for inserting the screwdriver blade. Save the port cover
for future use.
Step 2
Remove the X2 transceiver from its protective packaging.
Note
Step 3
Check the label on the X2 transceiver body to verify that you have the correct model for your network.
OL-5781-08
Cabling a CX4 (Copper) XENPAK Transceiver
4X InfiniBand
connector
Do not remove the optical bore dust plugs until directed to do so later in the procedure.
XENPAK-10GB-CX4
Catalyst 6500 Series Switches Installation Guide
Attaching the Interface Cables
3-73
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6503 - Catalyst Firewall Security Sys
Related Products for Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series
- Cisco CATALYST 6500 WS-X6066-SLB-S-K9